![](/images/stories/virtuemart/product/KyoceraEasySmartphone38.jpg)
Application processor, Chipset:
CPU ClockFrequency of the square signal which schedules the internal operation of microprocessor (synchronous sequential logic). The current consumed by the processor is approximately proportional to clock rate. 2200 MHz
CPUManufacturer part number and most important characteristics of the IC which includes the main application processor or processors MediaTek Dimensity 700 MT6833V/ZA, 2020, 64 bit, octa-core, 7 nm, ARM Mali-G57 GPUMediaTek Dimensity 700 MT6833V/ZA, 2020, 64 bit, octa-core, 7 nm, ARM Mali-G57 GPU
Operative MemoryOperative Memory:
RAM TypeType of volatile memory IC which specifies RAM architecture, timing characteristics, refresh mode, voltage levels and physical design of the IC. Two major types of random-access memory is static RAM (SRAM) periodically refreshed dynamic RAM (DRAM). LPDDR4x SDRAM
2133 MHzClock frequency of the RAM databus (not necessarily equivalent to data transfer frequency). The width of the databus (e.g. 64 bit), RAM type (e.g. DDR SDRAM), number of channels and clock rate (e.g. 200 MHz) determines peak transfer rate
RAM Capacity (converted)RAM capacity in binary bytes (KiB: 1024 bytes, MiB: 1024 KiB, GiB: 1024 MiB) 4 GiB RAM
Non-volatile MemoryNon-volatile Memory:
Non-volatile Memory InterfaceInterface (e.g. UFS 2.0, eMMC 5.1, moviNAND) which determines physical layer (width, clock rate, lanes, protocol) of data transfer between the application processor and the NV memory UFS 2.1UFS revision 2.1 (released in 2016) defines single-lane 600 MB/s or dual-lane 1.2 GB/s NAND flash EEPROM interface
Non-volatile Memory Capacity (converted)The value of ROM capacity converted to the most appropriate units (KiB: 1024 bytes, KB: 1000 bytes, MiB: 1024 KiB, MB: 1000 KB, GiB: 1024 MiB, GB: 1000 MB) 64 GB ROM
DisplayDisplayAll parameters that related to display
Display NotchNumber of display notches (or cutouts) 1-notch
Display DiagonalThe distance measured between the furthest corners of the display. In case of display with rounded edges this refers to the diagonal of the smallest bounding rectangle. 155 mm
6.1 inchDisplay Diagonal in inches
ResolutionHorizontal and vertical resolution of the primary display. In case of display with rounded edges this refers to the smallest bounding rectangle. 1080x2400
Horizontal Full Bezel WidthDefined as the sum of width of left and right vertical display bezels. If the display panel is located in the middle width of left and right bezels are the same and their width is the half of the full bezel width. 6.39 mm
Display Area UtilizationRegular display area per regular front panel area ratio. This approximated indicator does not count with possible rounded corners (neither on front panel nor on display) or display notches, holes. 79.8%
Pixel DensityIndicates the number of pixels per inch 431 PPI
Display TypeDisplay technology, e.g. Color/ monochrome e-ink, STN, PM-OLED, AM-OLED, TN-TFT, IPS TFT, ASV TFT, MVA TFT, PVA TFT, PLS TFT Color IPS TFT LCDColor IPS-TFT (In-Plane Switching - Thin Film Transistor) is also called Super TFT LCD. This is an active matrix LCD technology developed by Hitachi Ltd. in 1996. display
Number of Display ScalesMaximal number of displayable colors or scales 16.8M
Scratch Resistant ScreenUsual types: Gorilla Glass generations, DragonTrail/X, Sapphire Glass Yes
Graphical Subsystem:
Graphical ControllerManufacturer and part number of the graphics controller IC or commercial name of the intellectual property (IP) if the graphics controller is the part of a chipset ARM Mali-G57MP2
GPU Clock: 955 MHz
Audio/Video InterfacesAudio/Video Interfaces:
A/V OutAudio/Video outputs form a heterogeneous group of interfaces that allow the user to connect the device to various external analog/digital multimedia devices (monitors, projectors, HD TVs) and play multimedia content. For example: MHL, DisplayPort, HDMI, e No
Audio SubsystemAudio Subsystem:
Microphone(s)Analog or digital sound receiver. Main applications: voice calls, active noise cancellation, voice command, voice/video recording, voice identification stereo
Loudspeaker(s): mono
Audio Output: Yes
Primary Camera SystemPrimary camera usually has better imaging capabilities than secondary camera if any
Camera PlacementRefers to the placement of the primary camera on the device. Front, rear or rotatable. Generally rear. Rear
Camera Image SensorRefers to the semiconductor technology of image sensor (FSI CMOS, BSI CMOS, etc.) BSI CMOSBackside Illuminated CMOS (Complementary MOS circuit)
Image Sensor Pixel SizePixel size of the primary camera sensor 1.12 micrometer
Number of effective pixelsA measurement of the maximum pixel number at which the camera can take a picture, often referred to as Megapixels (when horizontal and vertical measurements are multiplied) 15.9 MP camera
ZoomA feature that changes the focal length of the lens of a camera. Optical zoom requires the lens to move in and out, providing high-quality close ups from a distance 1.0 x optical zoom
FocusCD AF, PD AF, Laser AF, etc. No / Not supported means there is no adjustable optical system or no camera built-in at all PD AFPhase-detection (PD) is a passive autofocus system which measures the phase difference between a two images to reach correct focus.
Video RecordingA measurement of the maximum horizontal and vertical pixel numbers at which the primary camera can capture video 1920x1080 pixel
30 fpsRecording frame rate when recording video at maximum resolution
FlashA flash is used to brighten dark areas when taking photographs; is also used as a flashlight. This field contains the exact type of the flash. single LEDAlso known as mobile light
Camera Extra FunctionsPopular extra features of the primary camera: EIS, EIS for video, OIS, OIS for video, Face detection, 3D photo, HDR photo, HDR video, Macro mode, Panorama Photo, Red-eye reduction, Refocus, Smile detection, Slow motion video, Burst mode, Face Retouch EISEIS (or digital IS) uses further buffer pixels around the active pixel matrix and dinamically shifts the recorded image in 4 direction to compensate the motion of the camera. , EIS (video) , HDR photoHigh dynamic range image recording , Slow motion videoSlowmo cameras are able to achieve at least 100 frame per second frame rate. , Burst mode , Macro modeAn autofocus feature that allows for close-up photographs to be taken with the onboard digital camera , Panorama Photo , Face detection , Face tagging , Smile detection , Face retouch
Aux. Camera Image SensorAuxiliary camera image sensor technology in at least dual lens setup No
Aux. 2 Camera Image SensorAuxiliary 2 camera image sensor technology in at least triple lens setup No
Aux. 3 Camera Image SensorAuxiliary 3 camera image sensor technology in at least quad lens setup No
Aux. 4 Camera Image SensorAuxiliary 4 camera image sensor technology in at least penta lens setup No
Secondary Camera SystemSecondary Camera SystemWidely used for video telephony or taking selfies
Secondary Camera PlacementRefers to the placement of the secondary camera on the device. Front or rear. Generally front camera for selfies or video call. Front
Secondary Camera SensorRefers to the semiconductor technology of sec camera image sensor (FSI CMOS, BSI CMOS, etc.) CMOSComplementary MOS circuit
Secondary Camera Number of pixelsA measurement of the maximum pixel number at which the sec. camera can take a picture, often referred to as Megapixels (when horizontal and vertical measurements are multiplied) 8.0 MP sec. cam
Secondary Video RecordingA measurement of the maximum horizontal and vertical pixel numbers at which the secondary camera can capture video 1920x1080 pixel
Secondary Camera Extra FunctionsPopular extra features of the secondary camera: Face detection, HDR photo, Selfie Panorama, Smile detection, Face Retouch / Face Beautification HDR photoHigh dynamic range image recording , Burst mode , Face detection , Face tagging , Smile detection , Face retouch
Sec. Aux. Cam. Image SensorImage sensor technology of sec. auxiliary camera in at least dual lens secondary camera setup No
Built-in SensorsBuilt-in Sensors:
Built-in compassBuilt-in electroinc compass types: 1D, 2D, 3D Yes
Built-in accelerometerAn internal component that senses acceleration components of the device. Used for automatic screen rotation and for games and applications that rely on acceleration measurement on X, Y, and Z axis. Possible types: 1D, 2D, 3D Yes
Built-in gyroscopeAn internal component that senses the orientation of the device. Used for automatic screen rotation and for games and applications that rely on the devices position in the X, Y, and Z axis. Possible types: 1D, 2D, 3D Yes
Additional sensorsBuilt-in ambient (barometer, temperature, altimeter, light, etc.), biometric (fingerprint, HR, step, etc.) and comfort (hall sensor, gesture sensor, proximity, etc.) sensors FP sensorDevice is able to identify the user by using a built-in dedicated biometric fingerprint recogniser sensor placed at the front, rear or any side of the device , L sensorBy measuring the intensity of the ambient light device may control the brightness level of the screen , P sensorBased on this sensor signal device may control the volume of the voice speaker or dim the display during a call , Step counter
Power Supply:
BatteryBattery technology Li-ion polymer (LiPo)
built-inPossible options: removable, built-in
1-cellIn case of high power consumption it is more efficient to connect more than 1 cells in the battery in series to minimize current thus loss.
Nominal Battery CapacityIf there are more than 1 cells in the battery in parellel connection the nominal resulting battery capacity is the sum of capacity of cells 4500 mAh battery
Talk Time: 35.0 hours
Address: 2457 W. Devon Ave. Chicago, IL 60659, USA
Email: labbek@aol.com
Phone: 1.773.274.3764